High-Ratio Heat Sink Replaces Bonded-Fin Solution
Methode was approached to find a replacement for a bonded-fin heat sink prototype that was too large, too heavy and too expensive.
Cost-Saving New Thermal Management Enclosure for Welding
A welding-equipment manufacturer wanted their next-generation product contained within the existing legacy enclosure, while maintaining sufficient air flow.
Liquid-Cooled Chill Plate Redesign
Methode was approached to fabricate a customer-designed, liquid-cooled brazed heat sink.
Improved Telecommunications Power Systems
Methode was asked to design a fuse panel that would increase current capacity, as well as reduce internal system temperature rise.
Telecommunication Data Router Assembly
Methode was approached to assist on the design of a new router and power distribution systems housed in a 43U server rack cabinet.
Laminated Bus Bar for Aerospace Application
To create a small, yet efficient, power distribution system located in a military helicopter blade hub.
Bus Bar Solution for Misalignment in Scalable Server System
Methode worked with the customer’s engineers to optimize a scalable design for increasing the capacity of a high-end server where the system operates at a very low DC voltage.
Laminated Bus Bar Saves Product Launch
Methode was asked to design a power distribution unit that replaced an in-house design and met a customer’s impending release date.
Router Power Cable from Power Supply to Backplane
Methode was approached to connect a 50A source to a backplane situated around a very sharp corner, and make the backplane connection both secure and robust.
Multi-Wire FusionLug® Solves Reliability Problems
Methode was approached to improve the reliability of an existing power-cable system used to distribute 48 VDC to three separate loads.
